How to Set Up the 180 Wing Awning with Your Roofnest Tent

Quick answer

Mount the 180° Wing Awning to your roof rack or tent brackets, then deploy it from its ABS hard case in seconds. No zippers or poles are needed—just pivot the arms and extend the legs.

Step-by-step setup process

1. 1. Mount the hard case to your vehicle: Position the ABS hard case on your roof rack crossbars or tent mounting brackets. Use the supplied U-bolts and brackets to secure it. Tighten evenly so the case sits level and doesn't shift during travel. Common mistake: over-tightening can crack the case—use firm hand pressure only.
2. 2. Unlatch and lift the lid: Release the two side latches on the hard case. Lift the lid fully until it locks open. The awning fabric is packed inside; unfold it gently to avoid creasing. Checkpoint: make sure the lid is fully engaged before pulling out the arms. If the lid doesn't lock, check that the latch springs aren't obstructed by debris.
3. 3. Pivot the arms outward: Grasp one aluminum arm at the hinge and rotate it 180° until it clicks into the open position. Repeat for the opposite arm. The arms extend smoothly on their hinges—do not force them if they resist. Common mistake: trying to pivot both arms at once can pinch fingers.
4. 4. Extend and adjust the legs: Pull each leg down from the arm until the foot touches the ground. Twist the locking collar to secure the leg at the desired height. Adjust so the fabric is taut but not stretched. Checkpoint: if the ground is uneven, shorten one leg slightly to keep the awning level. On soft ground, place a flat rock or a ground pad under each foot to prevent sinking.
5. 5. Connect the battery-powered LED strip (optional): If you have the integrated LED lighting, plug the connector into the battery pack and attach the strip to the underside of the awning arms using the included clips. Turn on the switch to test. Common mistake: leaving the strip on during the day drains the battery—turn it off when not needed.
6. 6. Stow in reverse order: To pack up, remove the LED strip, retract the legs, fold the arms back into the case, and close the lid. Secure both latches. Common mistake: folding the fabric unevenly can cause it to bunch and prevent the lid from closing fully. Fold the fabric in thirds lengthwise before tucking it in—this keeps the lid flush.

What you need

• 180° Wing Awning: The 180° Awning sets up in seconds from a sleek, durable ABS hard case, providing 80 sq. ft. of coverage, free of cumbersome zippers that can stick, snag, or break. No zippers means you can deploy and stow the awning quickly in changing weather without wrestling with stuck fabric.