Before You Start: Compatibility Check
Roof top tent quick release mounts let you remove your tent in seconds, freeing up roof space for kayaks, bikes, or improving fuel mileage. But getting the fit right matters. The VanUltra Roof Top Tent Quick Release Mounts require a minimum 3.5" of clearance below the tent mounting rail so you can reach the mounting system. If your rack sits lower than that, you won't be able to operate the mounts. Do the "credit card test": you must be able to fit a card's length between your tent and vehicle.
These mounts are not compatible with Rhino Rack Pioneer platforms or Gobi roof racks. For low-profile racks like Sherpa or Prinsu, check an alternative product. The mounts work with most round tubular, rectangular, and brand-specific crossbars. Rectangular bars must be 0.75" to 2.1" in height and up to 3.3" in width. Round tube bars need an outside diameter between 1.1" and 2.1".
Three Steps to Verify Compatibility
- 1. Check your clearance: Ensure you can maneuver your hand underneath your rack to operate the mounting system. A minimum 3.5" of space is needed below the tent mounting rail. If you have a low-profile rack, this product may not fit.
- 2. Check your tent: Look at your tent mounting rail and match the geometry shown in the product images for Option A, B, or C. Each option has different hardware at the top that best fits your tent rail. You can also search for your tent model in the compatibility matrix.
- 3. Check your rack: Measure your crossbars. For rectangular bars: minimum 0.75" height, maximum 2.1" height, maximum 3.3" width. For round tube: outside diameter 1.1" to 2.1". If your bars are wider, you may need the Wide Bar Fit Kit.
Key Features of the Quick Release Mounts
- Roof Top Tent Quick Release Mounts: Low profile – no height added to the tent Keeps your overall vehicle height low, which helps with garage parking and fuel economy.

Roof Top Tent Quick Release Mounts - Roof Top Tent Quick Release Mounts: No tools required after initial install Once set up, you can remove or reinstall the tent in seconds without wrenches or screwdrivers.
- Roof Top Tent Quick Release Mounts: Stainless steel parts won't rust if trimmed or ground down If minor modifications are needed for a proper fit, the hardware remains corrosion-resistant.
Installation Overview: Drop and Drive
The "drop and drive" method means you set the tent alignment once with the fixed side of the mount, then simply drop the tent into place and drive the locking pins. After the initial install, no tools are needed. The mounts include a quick-release / disconnect feature and accept 1/2" hitch pins for locking (sold separately).
Important: slight variations in tent rails may require minor modifications for a proper fit. The stainless steel construction allows you to trim or grind parts without worrying about rust. Always verify compatibility before starting.

